Datasheet

Assemble and Test your BOE Shield-Bot • Chapter 3
Robotics with the BOE Shield-Bot • 81
Mount the Battery Pack
Parts List
(2) Nylon flat-head slotted screws, 3/8″ 4-40
(2) 1" standoffs (removed from BOE Shield previously)
(1) 5-cell battery pack with 2.1 mm center-positive plug
Instructions
 Place the empty battery pack inside the chassis positioned as shown above. The
easiest method is to insert one side, then press down on the other side until it is
flush with the chassis. The fit may be snug, but it should snap into place using a
small amount of force (below).
3/8” Nylon screws will go through outer holes and be secured to chassis with 1” standoffs.