Datasheet

Assemble and Test your BOE Shield-Bot • Chapter 3
Robotics with the BOE Shield-Bot • 77
Tools
All of the tools needed are common and can be found in most households and school shops.
They can also be purchased at local hardware stores. The Parallax screwdriver is included in
the Robotics Shield Kit, and the other two are optional but handy to have.
(1) screwdriver, Phillips #1
(1) 1/4″ combination wrench (recommended if you
choose to use the Nylon-core lock nuts)
(1) needle-nose pliers (optional)
 Disconnect the programming cable and
battery pack from your Arduino.
 Disconnect the servos from the BOE Shield.
 Set the BOE Shield’s 3-position power
switch to position 0.
Mount the Topside Hardware
Parts List
(1) robot chassis
(2) 1″ standoffs (removed from BOE Shield)
(2) pan-head screws, 1/4″ 4-40 (removed from BOE Shield)
(1) rubber grommet, 13/32″