Crawler assembly manual

Step #5 Installing Middle Legs

Item Qty Description

(K) (2) 3Mx12 Phillips Pan Head Screw

(Q) (2) Plastic Screw Covers

Use Fig #10 as a guide to install the middle leg assembly

just built.

Insert Screws (K) through Screw Covers (Q). Insert the

Screw through the long slide hole of the Leg assembly.

Screw into standoff (H). Tighten until each leg can slide

freely but is not sloppy. Before moving on, position the

pieces exactly as they appear in Fig #11 with the top

Push Arm to the right. Double check your work then

proceed to Step #6.

Fig #10 Fig #11

Step #6 Connecting Push arms to Legs

Item Qty Description

(E) (8) Nylon washers

(L) (4) M3x10 Phillips Pan Head Screw

(N) (4) Nylon Lock Nuts

(Q) (4) Plastic screw covers

Use Fig #12 as a guide to connect push Arms (G) to Legs

(C). Be sure Push Arms are aligned as shown in Fig #11.

Insert screws (L) through screw covers (Q). Next insert

screw through hole of Leg (C), then through a Nylon Washer

(E), and through the push arm (G). Next insert the screw

through another Nylon Washer and tighten with a Locknut

(N) from back of the Push Arm. Tighten until legs can just

move freely but are not sloppy. Before moving on, position

the pieces exactly as they appear in Fig #13 and Fig #14.

Double check your work then proceed to Step #7.

Fig #12 Fig #13 Fig #14

E E

C C

G G

These Two

Push Arms

Must Be on