BASIC stamp manual v2.2
Quick Start Guide
Page 30 • BASIC Stamp Syntax and Reference Manual 2.2 • www.parallax.com
development board or a breadboard, carefully follow the
Programming Connections guidelines on page 27 before proceeding.
Figure 2.1: BS1-IC, BS1 Carrier
Board, and BS1 Serial Adapter
1) Insert the BASIC Stamp module
into its socket, being careful to
orient it properly.
2) Connect the 9-pin female end of
the serial cable to an available serial
port on your computer, then attach
the male end to the BS1 Serial
Adapter, Note: you cannot us a null
modem cable.
3) Plug the BS1 Serial Adapter into
the programming header on the BS1
Carrier Board.
4) Plug a 9 volt battery into the 9
VDC battery clip.