Quick Start Guide

All waters looks murky with a dirty lens! Make sure your lens is clean and
has no scratches. To clean the lens, wipe it with a soft, lint-free cloth. You
can use Eyeglass Cleaning Fluid – but do not use strong solvents such as
benzene or alcohol.
Check that the o-rings have not been stretched and that they do not have
any cuts, tears and dirt (hair, dust). To lubricate the o-rings apply a thin
layer of grease and run them through your fingers while gently rubbing
the grease into the o-ring (do not use spray lubricant or petroleum based
grease).
Maintenance
The triple o-rings are tested to 250 m/820 ft./26 ATM. , so as long as you
properly maintain the o-rings and don’t open the camera below water you
should be fine. Remember to put on the end cap correctly.
We recommend to rinse the camera in fresh, warm water, while working
the ring and switch. Also - no solvents/chemicals should be used while
cleaning. If sand grains should get stuck underneath the magnetic
switches please contact our support for instructions.
Cleaning the camera
How do I prevent the camera from flooding?
Cleaning the o-rings
Cleaning the lens
10