Installation Guide

2. Check the guide tracks, your Guide tracks (05 &12) has been precut for
your Shower model width:60”.
If W-width of your wall-to-wall opening is equal to the size of your Shower
model, it is unnecessary to cut the Guide tracks. If W-width of your
wall-to-wall opening is less than the size of your shower model, you will
need to cut the Guide tracks. You can choose to cut from any side you like.
The length to cut off will be L=Subtract W from the size of your Shower Model.
Please see image 2 details:
Fig 2
3. In order to make it easy for following installation of frames, it’s better to
tapping on both sides of the upper and bottom guide tracks. Use Philip’s
screw ST4*(40) to lock to both ends of upper and bottom guide track, then
loosen the screws.
Please see Fig 3 for details
Warm tips: please note down the distance from edge to screw hole center,
marked with N, new holes drilling position on the guide tracks after cutting will be
N.