Installation Guide

10
Philip’s head
countersunk
self-tapping screw
ST5*40
8pcs
27
Moving glass
1pc
11
Philip’s head screw
ST4*30
4pcs
28
Stationary glass
1pc
12
Philip’s head screw
ST4*8
4pcs
29
handle
1pc
13
Philip’s head screw
ST4*16
2pcs
30
14
Φ
5/16” wall anchor
9pcs
31
Support bar Glass clamp
pad
1pc
15
Φ 1/4” wall anchor
7pcs
32
Philip’s head screw
ST4*25
1pc
16
Water leading block
1pc
33
Philip’s head screw
ST5*35
1pc
17
Water leading groove
7pcs
34
WARM TIPS
01:
Open the packaging carefully and inspect all the necessary parts using
detailed diagram and component list in your manual as a reference. Before
discarding the carton, check for small hardware bags that tend to fall to the
bottom of the box. If any parts are damaged or missing, please contact us for
replacement.
02:
Retain these installation instructions for future use if in need.
INSTALLATION STEPS:
1.Install Moving glass
1.1 Install waterproof strip (04) to the moving glass (27) and later install
two hinges (26) to the cutting groove of the glass.
1.2. Place the moving glass to the wall vertically and level it, than draw hinge
holes on the wall.
Please see Fig 1 for details