Installation Guide

2. Your Upper Guide rail tube (03) has been precut for your Shower model
opening width:59” for shower width. If W-width of your wall-to-wall opening is
equal to the size of your Shower model, it is unnecessary to cut the Upper
Guide rail tube and you can continue to Step 3. If W-width of your wall-to-wall
opening is less than the size of your Shower model, you will need to cut the
Upper Guide rail tube from the end which is farther from the Glass brackets
(06) holes. The length to cut off will be L=Subtract W from the size of your
Shower Model.
Please see Fig 2 details:
Fig 2
3. Install stationary glass
3.1. Install sealing strip (02) on the side which will connect to the wall of the
stationary glass (17).
3.2. Assemble wall clamp (13) on the stationary glass (17).
3.3. Install sealing strip (02) at bottom of stationary glass (17).
3.4. Place the stationary glass to the wall, level it and draw holes through the
holes on wall clamp(13).
Please see Fig 3 for details