Installation Guide

6.Install Threshold(23).
6.1.Place the threshold(23) to the shower base, in same level of the bottom of
stationary glass, then place fixed clamp-R(20) to the end of the threshold
which close to the stationary glass, make sure the clamp groove to grip the
stationary glass. place the fixed clamp-L(21) to the end of the threshold which
close to the wall.
6.2 Draw holes on the base through the holes on fixed clamps.
6.3 Use
Φ
1/4” drill bit to drill holes on the base,knock in the
Φ
1/4” anchors
and then use philip’s screw ST4*16 to lock the fixed clamps and threshold to
the tub.finally use screw covers to cover the screw holes.
Please see Fig 14 for details.
02
03
01