Installation Guide

12.Adjustment.
12.1.Pull out the pulley wheels from the upper profile sloth (before doing this
please use some cardboards to hold the bottom of the moving glass to keep
the weight from the pulley wheels).use philip’s head screw driver to turn the
screw which under the wheel sheath to adjust the moving glass and make it up
or down(turn with clockwise will make moving glass a little down, while
anticlockwise will make moving glass a little up)
Please see Fig 20 for details
Fig 20
12.2.Pull out the wheel sheath a little bit and use screw driver to adjust its
height, use the philip’s head self-tapping screws ST4*12(15) to lock the wheel
sheath to the stationary glass profile and covered by transparent screw
covers(21).
Please see Fig 21 for details
Fig 21