User manual

168

3. You will be notified on the successful accomplishment of the operation. Click Yes to load another driver or No to

close the dialog.

Our WinPE 3.0 recovery environment is 32-based, thus you need to use 32-bit drivers for

injection.

Configuring network

If your local network has a DHCP server, a network connection will be automatically configured once our WinPE

recovery environment has been started up. Otherwise you will need to do it manually with a handy dialog by providing

an IP address, a network mask, default gateway, etc. Besides with its help you can easily map network shares.

To manually set up a network connection and map a network share, please do the following:

1. Once you accept the agreement, you will see the Universal Application Launcher. Click Configure Network.

2. In the opened dialog provide an IP address, a network mask, default gateway, etc. for your network device.

3. Click the Network drivers tab to map a network share.

4. Click Map Network Drive and provide all the necessary information to map a network share in the opened

dialog: