Instructions / Assembly

6. Tighten the Nut M8 on the reflector.Then
u
se Bolt M8 to tighten the small hat on top of
the reflector.
6
o
rtionTop p
panelsmBotto
kitWheel
plateBase
Hardware Used
2
T
op View
N
ut M8
Q
ty.
3
Bolt M8×30 mm
Q
ty.
1
W
rench
Qty. 1
Philips screwdriver
Qty. 1
Assembly Instructions
Note: Before installation, please wear gloves,
press the lower seat of the glass tube, let it
loose, then install the glass tube!
5. Loosen the top nut M8 x3 under the
reflector in clockwise direction. Then lift the
emitter by one hand and place the glass tube
inside. Gently pull downward on the emitter,
and tighten the nut M8 x3 under the reflector
in a counterclockwise direction.
6. Tighten the nuts M8 x3 (HH) on the reflector.
These were hand tightened from step 1.
Use bolt M8 (FF) to attach reflector cover (AA)
on top of the reflector as shown in fig 6.
(from step 1)
x3
AA
AA
Reflector Cover
Qty. 1