Modem User's Guide
Table Of Contents
- Contents
- Warranty, Sales, and Service Information
- About This Guide
- About the Model 7986 Standalone Termination Unit
- Using the Asynchronous Terminal Interface
- Initial Startup and Configuration
- Monitoring the Unit
- Testing
- Messages and Troubleshooting
- Security
- IP Addressing
- Configuration Option Tables
- Standards Compliance for SNMP Traps
- Cables and Pin Assignments
- Technical Specifications
- Glossary
- Index
Testing
5-9
7986-A2-GB20-00
September 1998
Ending an Active Test
Except for the Remote Send Line Loopback and Remote DCLB, a test initiated by
the user can be ended by the user. Tests can also be terminated automatically by
enabling the Test Timeout option from the System Options Menu.
H A Test Timeout option is available to automatically terminate a user-initiated
Loopback or Pattern test (as opposed to manually terminating a test) after it
has been running a specified period of time. The default is 10 minutes. Refer
to Table A-3, System Options.
Test Timeout does not pertain to tests initiated by the network.
H On each test screen is a Command column. To stop the test, press Enter
when the cursor is on the Stop command.
H Use the Abort All Tests selection from the Test menu to stop all tests running
on all interfaces, with the exception of network-initiated loopbacks. Command
Complete appears when all tests on all interfaces have been terminated.
An aborted test may continue to run for a few seconds as the abort command
is sent to the remote end and processed.