Modem User's Guide
Table Of Contents
- Contents
- Warranty, Sales, and Service Information
- About This Guide
- About the Model 7986 Standalone Termination Unit
- Using the Asynchronous Terminal Interface
- Initial Startup and Configuration
- Monitoring the Unit
- Testing
- Messages and Troubleshooting
- Security
- IP Addressing
- Configuration Option Tables
- Standards Compliance for SNMP Traps
- Cables and Pin Assignments
- Technical Specifications
- Glossary
- Index
5-1
7986-A2-GB20-00
September 1998
Testing
5
Accessing the Test Menu
From the Test menu, you can run network tests, data port tests, and a front panel
lamp test.
To access the Test menu, follow this menu selection sequence:
Main Menu
→
Test
main/test Hotwire
Model: 7986
TEST
Network & G.703 Tests
Device Tests
Abort All Tests
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu M
ainMenu Exit
Select . . . To . . .
Network and G.703 Tests Start and stop tests on the G.703 network interface.
Device Tests Start and stop lamp test.
Abort All Tests To abort all current tests excluding G.703 and
Network-initiated loopback tests. An aborted test may
continue to run for a few seconds as the abort
command is sent to the remote end and processed.