Modem User's Guide
Table Of Contents
- Contents
- Warranty, Sales, and Service Information
- About This Guide
- About the Model 7986 Standalone Termination Unit
- Using the Asynchronous Terminal Interface
- Initial Startup and Configuration
- Monitoring the Unit
- Testing
- Messages and Troubleshooting
- Security
- IP Addressing
- Configuration Option Tables
- Standards Compliance for SNMP Traps
- Cables and Pin Assignments
- Technical Specifications
- Glossary
- Index
Monitoring the Unit
4-2
7986-A2-GB20-00
September 1998
Viewing System and Test Status
To view System and Test Status information, follow this menu selection
sequence:
Main Menu
→
Status
→
System and Test Status
main/status/system Hotwire
Model: 7986
SYSTEM AND TEST STATUS Page 1 of 1
HEALTH AND STATUS SELF-TEST RESULTS TEST STATUS
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
LOS at Net, Pt 1 Device Failed No Test Active
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
ESC for previous menu M
ainMenu Exit
PgU
p PgDn
The System and Test Status screen has three sections:
H Health and Status – Displays messages in priority order (highest to lowest).
Refer to Table 4-1, Health and Status Messages.
H Self-Test Results – Results of the Diagnostic test run on the device itself.
Refer to Table 4-2, Self-Test Results Messages.
H Test Status – Currently active tests. Refer to Table 4-3, Test Status
Messages.