Modem User's Guide
Table Of Contents
- Contents
- Warranty, Sales, and Service Information
- About This Guide
- About the Model 7986 Standalone Termination Unit
- Using the Asynchronous Terminal Interface
- Initial Startup and Configuration
- Monitoring the Unit
- Testing
- Messages and Troubleshooting
- Security
- IP Addressing
- Configuration Option Tables
- Standards Compliance for SNMP Traps
- Cables and Pin Assignments
- Technical Specifications
- Glossary
- Index
B-1
7986-A2-GB20-00
September 1998
Standards Compliance for
SNMP Traps
B
SNMP Traps
This section describes the unit’s compliance with SNMP standards and any
special operational features for the SNMP traps supported. The unit supports the
following traps:
H warmStart
H authenticationFailure
H linkUp
H linkDown
warmStart
SNMP Trap Description Possible Cause
warmStart The unit has reinitialized
itself.
The trap is sent after the
unit resets and stabilizes.
There are no
variable-bindings.
H Reset command.
H Power disruption.
authenticationFailure
SNMP Trap Description Possible Cause
authenticationFailure Failed attempts to access
the unit.
There are no
variable-bindings.
Three unsuccessful attempts
were made to enter a correct
login/password combination.