User's Manual
Table Of Contents
- Contents
- About This Guide
- About the FrameSaver DSL Unit
- User Interface and Basic Operation
- Configuration Procedures
- Configuration Options
- Overview
- Using the Easy Install Feature
- Setting Up So the Router Can Receive RIP
- Entering System Information and Setting the System Clock
- Configuration Option Tables
- Configuring the Overall System
- Configuring the Physical Interfaces
- Configuring Frame Relay for the Data Port
- Configuring ATM for the Network Interface
- Configuring Circuit and DLCI Records
- Configuring PVC Connections
- Setting Up Management and Communication Options
- Configuring Node IP Information
- Configuring Management PVCs
- Configuring General SNMP Management
- Configuring Telnet and/or FTP Session Support
- Configuring SNMP NMS Security
- Configuring SNMP Traps
- Configuring the Ethernet Port
- Configuring the Communication Port
- Configuring the COM Port to Support an External Modem
- Security and Logins
- Operation and Maintenance
- FTP Operation
- Troubleshooting
- Setting Up OpenLane for FrameSaver Devices
- Setting Up Network Health for FrameSaver Devices
- Menu Hierarchy
- SNMP MIBs and Traps, and RMON Alarm Defaults
- Connectors, Cables, and Pin Assignments
- Technical Specifications
- Equipment List
- Index
Configuration Options
4-33
9783-A2-GB20-00
July 2000
Configuring Telnet and/or FTP Session Support
Telnet and FTP options control whether a Telnet or FTP (File Transport Protocol)
session is allowed through an interconnected IP network and the access security
applicable to the session. Two Telnet sessions can be active at a time
(see Table 4-14).
Main Menu
→
Configuration
→
Management and Communication
→
Telnet and FTP Session
When a TS Management Link has been set up and activated, the following
options have no effect upon the PVC:
H Telnet Login Required
H Session Access Level
H FTP Login Required
Table 4-14. Telnet and FTP Session Options (1 of 3)
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies whether the FrameSaver unit will respond to a session request from a Telnet
client on an interconnected IP network.
Enable – Allows Telnet sessions between the FrameSaver unit and Telnet client.
Disable – Does not allow Telnet sessions.
Telnet Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether a user ID and password (referred to as the login) are required to
access the menu-driven user interface via a Telnet session. If required, the login used is
the same login used for an menu-driven user interface session. This option does not
affect the TS Access Management Link.
Enable – Requires a login to access a Telnet session.
Disable – Does not require a login.