User's Manual
Table Of Contents
- Contents
- About This Guide
- About the FrameSaver DSL Unit
- User Interface and Basic Operation
- Configuration Procedures
- Configuration Options
- Overview
- Using the Easy Install Feature
- Setting Up So the Router Can Receive RIP
- Entering System Information and Setting the System Clock
- Configuration Option Tables
- Configuring the Overall System
- Configuring the Physical Interfaces
- Configuring Frame Relay for the Data Port
- Configuring ATM for the Network Interface
- Configuring Circuit and DLCI Records
- Configuring PVC Connections
- Setting Up Management and Communication Options
- Configuring Node IP Information
- Configuring Management PVCs
- Configuring General SNMP Management
- Configuring Telnet and/or FTP Session Support
- Configuring SNMP NMS Security
- Configuring SNMP Traps
- Configuring the Ethernet Port
- Configuring the Communication Port
- Configuring the COM Port to Support an External Modem
- Security and Logins
- Operation and Maintenance
- FTP Operation
- Troubleshooting
- Setting Up OpenLane for FrameSaver Devices
- Setting Up Network Health for FrameSaver Devices
- Menu Hierarchy
- SNMP MIBs and Traps, and RMON Alarm Defaults
- Connectors, Cables, and Pin Assignments
- Technical Specifications
- Equipment List
- Index

SNMP MIBs and Traps, and RMON Alarm Defaults
B-7
9783-A2-GB20-00
July 2000
Trap: warmStart
This trap indicates that the FrameSaver unit has been reset and has stabilized.
Table B-3. warmStart Trap
Trap
What It Indicates Possible Cause
warmStart
FrameSaver unit has just
reinitialized and stabilized
itself.
H Reset command sent.
H Power disruption.
String:
Variable-Binding
String:
‘Unit reset.’
devLastTrapString
(devHealthAndStatus.mib)
Trap: authenticationFailure
This trap indicates that access to the FrameSaver unit was unsuccessful due to
lack of authentication.
Table B-4. authenticationFailure Trap
Trap
What It Indicates Possible Cause
authenticationFailure
Access to the FrameSaver
unit was attempted and
failed.
H SNMP protocol message not
properly authenticated.
H Three unsuccessful attempts
were made to enter a correct
login user ID/password
combination.
H IP Address security is enabled
and a message was received
from the SNMP Manager
whose address was not on the
lost of approved managers.
String:
‘Unauthorized access attempted.’
Variable-Binding
devLastTrapString
(devHealthAndStatus.mib)