User's Manual

Performing a system reset will set the Parakey to default
settings. Please note that if connected to a control panel,
the reset sequence of the Parakey will not cause the
control panel to reset and vice versa. To execute a
system reset perform the following:
1) Remove the power connections ("+12" & "GND") from
the receiver.
2) Press and hold the “PROG” button and re-connect the
power connections to the receiver.
3) Wait approximately 2 seconds and release the “PROG“
button. The red LED will flash for 15 seconds, the
keypad will beep, and all system settings will be reset
to factory default.
2.7 System Reset
8 9