User's Manual

INTRODUCTION
The PARAKEY is a wireless remote control system that
consists of a receiving module and up to eight 2 or 4-button
remote controls (transmitters). When used in conjunction
with any Paradox Esprit Series Control Panel , remote
controls can perform actions such as remote arming and
disarming, communicating panic alarms and/or activating
programmable outputs (PGMs). Each remote control is
assigned to a specific user and therefore, identifies the user
to the control panel when used. If desired, it can be used as
a stand-alone system where the remote controls will only
activate the on-board PGM outputs. When a button on the
remote control is pressed, it will transmit an RF signal.
When the PARAKEY receives this signal, it then processes
the request and performs the programmed action(s).
• Simple, user-friendly programming.
• Supports 8 User Codes, each linked to a unique RF
Code (2 or 4-button remote control).
• Encrypted RF codes for additional security. Does not
use DIP switch programming.
• 4 programmable outputs (PGMs).
• Stand-alone operation (trigger PGMs only) or in
conjunction with a Paradox Esprit Series Control Panel
(arm/disarm, panic & PGM activation).
• Programming keypad connects directly to the Parakey
Receiving Module.
• Programmable Installer Code.
• Software reset.
1.2.1 Receiver:
Compatible Programming Keypads: (616 V4.2A & up)
(626 V4.1A & up)
DC input: 12VDC
PGM outputs: 4
PGM Output 1-3 Current Rating: 30mA max.
PGM Output 4 Current Rating: 5A relay
Max Transmission Range: 53.34m (175 ft.)
Operating Conditions: 0°C to 50°C
Operating Humidity: 85%
Operating Frequency: 318 or 433.92MHz
Sensitivity: -110dbm
1.2.2 Remote Control:
Water Resistant
Battery: Lithium 3V (CR2032)
Battery Life: Apprx. 2 years
Power Transmission: 7mW
Current Consumption: 6mA (transmission)
1.2 Technical Specifications
1.1 Features
2 3