User's Manual
Table Of Contents
- Things You Should Know
- Entering Programming Mode
- Installer Quick Keys
- Zone Programming
- Remote Control Button Programming
- System Timers
- On-board Programmable Outputs (PGMs)
- System Options
- Communicator Settings
- Report Codes
- System Settings
- Wireless Transmitter Assignment
- Wireless Output Assignment
- Wireless Keypad Assignment
- Wireless Repeater Assignment
- Wireless Programmable Output (PGM) Settings
- Wireless Supervision Options
- Wireless Repeater Options
- Appendix 1: PGM Event Table
- Appendix 2: Specifications
- Appendix 3: Connection Diagrams
- Power Connections
- Telephone Line Connections
- PGM Connections
- Hardwire Zone Connections
- Connecting the Radio Antenna (MG-6160 only)
- Connecting to a UIP-256
- X10 Transmitter Connections (MG-6160 only)
- Connecting Magellan to WinLoad
- Connecting a Paradox Memory Key (PMC-4)
- Tabletop Mounting
- Mounting Magellan on the Wall
- Appendix 4: Ademco Contact ID Report Codes
- Appendix 5: Automatic Report Code List
Magellan 25
Connecting to a UIP-256
Figure 12: Connecting to a UIP-256 Universal In-Field Programmer
X10 Transmitter Connections (MG-6160 only)
Figure 13: Connecting the X10 Transmitter
Back view of the
Magellan console.
Standard
DB-9 cable
(9-pin serial
cable)
Connect the 10-
pin cable of the
UIP-256 to the 10-
pin connector of
the Magellan
console
Download latest
firmware version of
Magellan from the
Paradox website at
paradox.com
UIP-256
Universal
In-Field
Programmer
Back view of the Magellan console.
Inverted
4-pin
RJ-11
cable
X10 transmitter
1. Connect one end of the inverted
4-pin RJ-11 cable into the X10
plug of the console.
2. Connect the other end of the
inverted 4-pin RJ-11 cable into the
X10 transmitter.
3. Plug the X10 transmitter into a
standard wall outlet.
1
2
3
Do not connect the X10
transmitter into this plug.
Inverted 4-pin
RJ-11 cable
For information on
programming the X10
features of Magellan, refer to
the X10 Operation User
Guide which can be found
and downloaded for free
from our Web site at
paradox.com.
Make sure that an inverted 4-pin
RJ-11 cable is used when
connecting the Magellan console to
the X10 transmitter. Note the pin
configuration below:
Magellan
Console
X10
Transmitter
Pin 1 Pin 4
Pin 2 Pin 3
Pin 3 Pin 2
Pin 4 Pin 1
X10 devices (transmitters,
modules, etc.) are not
supplied and cannot be
purchased through Paradox
Security Systems Ltd.