Installation Instructions

18 Reference & Installation Manual
Part 6: Wireless Features
The Spectra 1759MG allows for the addition of up to eight fully supervised Magellan wireless transmitters, and up to eight programmable
remote controls. To program a wireless fire zone, refer to Programming a Wireless Fire Zone on page 15.
6.1 Wireless Transmitter Programming
The programming of the wireless transmitters (detectors and door contacts) is accomplished in two steps:
1. Assign the wireless transmitter to the Spectra 1759MG.
2. Program the zones.
6.1.1 Assigning Wireless Transmitters to the Receiver
Sections [601] to [608]
Sections [601] to [608] represent expansion inputs 1 to 8 respectively. For example, section [601] is assigned to
expansion input 1, section [602] is assigned to expansion input 2, etc. (refer to Table 5). Each Expansion Input
represents a specific zone in the Spectra 1759MG system (see Table 4 on page 12).
Do not assign detection devices from different modules to the same expansion input. For example, do
not assign a wireless transmitter to section [601] and then connect a detection device to input Z1 of the
APR3-ZX8.
The serial number is located on the inside of the transmitter or you can use the Serial Number Display (see
page 19) to determine its serial number.
The transmitters must be activated once having been assigned to the Spectra 1759MG. To activate a
transmitter, insert the batteries and close the cover. To ensure proper synchronization between the control
panel and the transmitter, open and close the zone corresponding to the transmitter.
6.1.2 Deleting Assigned Wireless Transmitters
Sections [601] to [608]
6.1.3 Programming the Zones
The zones allocated to the wireless transmitters must be programmed. Refer to Zone Programming on page 12 for
more information.
Table 5: Sections and Expansion Inputs
Section # 6-digit Serial Number Expansion Input
[601] ___/___/___/___/___/___ Input 1
[602] ___/___/___/___/___/___ Input 2
[603] ___/___/___/___/___/___ Input 3
[604] ___/___/___/___/___/___ Input 4
[605] ___/___/___/___/___/___ Input 5
[606] ___/___/___/___/___/___ Input 6
[607] ___/___/___/___/___/___ Input 7
[608] ___/___/___/___/___/___ Input 8
How Do I Assign Wireless Transmitters to the Spectra 1759MG?
1) Press the [ENTER] key.
2) Enter your [INSTALLER CODE].
3) Enter the desired [
SECTION NUMBER] (from sections [601] to [608]).
4) Enter the 6-digit [SERIAL NUMBER] of the wireless transmitter.
How Do I Delete Assigned Wireless Transmitters?
1) Press the [ENTER] key.
2) Enter your [
INSTALLER CODE].
3) Enter the desired [
SECTION NUMBER] (from sections [601] to [608]).
4) Press the [0] key six times to clear the serial number.