Installation Manual

PE Smart Mini Gateway
Document No. [DOC-INS-0115-05] Date of last revision [31.05.2021]
Page 41 / 50
Notice
Changes or modifications made to this equipment not expressly approved by Paradox Engineering may
void the user’s authority to operate this equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense
Radiofrequency radiation exposure information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance of 50 cm between the radiator
and your body.
This equipment must not be co-located or operating in conjunction with any other antenna or
transmitter.
Product operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
The FCC ID label is pictured in Figure 31:
Figure 31. FCC ID label