Installation Manual

PE Smart Mini Gateway
Document No. [DOC-INS-0115-05] Date of last revision [31.05.2021]
Page 31 / 50
7. Product Configuration
The PE Smart Mini Gateway must be connected to the customer network via Ethernet port, configuring the
IP address to match local addressing plan.
7.1 Configuring the IP address (narrowband and broadband)
PE Smart Mini Gateway is delivered with pre-configured addressing. Please refer to PE Smart Mini
Gateway Configuration Sheet to find out the IP addressing set on your device.
To change the configuration, connect a PC directly to PE Smart Mini Gateway and configure a static IP
address on the same product subnet.
Point your browser to PE Smart Mini Gateway Narrowband IPv4 address to reach the device management
interface.
After login (credentials are available on PE Smart Mini Gateway Configuration Sheet), click on “IP
management” and enter the desired network configuration, as provided by your network administrator.
Click on “Save Item Configuration”. If available, please enter your DNS server IP address(es).
Figure 21. IP Management
The PE Smart Mini Gateway will apply the new configuration and try to redirect your browser to the new
web interface address. Connect PE Smart Mini Gateway to the customer’s local network, reconfigure the
client PC to its usual IP address and reload the page on your browser, or point the browser to PE Smart
Mini Gateway assigned IP address.