Installation Manual

PE Smart Gateway Neptune US
Installation manual
Document No. [DOC-INS-0059-02] Date of last revision [23.11.2018]
Page 21 / 30
5.4 NTP configuration
PE Smart Gateway Neptune US should have time configured by an NTP server. The product is pre-configured to use
public NTP servers.
If public NTP servers (UDP port 123) are filtered by your firewall, or if a DNS server is not available, other NTP servers
can be configured under AMI Settings/NTP. Enter one or more IP addresses or names, separated by commas in the
NTP/Servers textbox, then click on “Save Settings” and on “Restart AMI Service”.
If an NTP service is not available on your network, leave the NTP/Servers textbox blank, click on “Save Settings” and
then on “Restart AMI Service”, and manually configure time under the “Timezone” page.