Installation Manual

PE Smart Gateway Neptune US
Installation manual
Document No. [DOC-INS-0059-02] Date of last revision [23.11.2018]
Page 19 / 30
Product configuration
PE Smart Gateway Neptune US must be connected to the customer network via Ethernet port, configuring the IP address
to match local addressing plan.
Three different network devices are embedded on PE Smart Gateway Neptune US, and each of them is reachable from
the external Ethernet port:
• Narrowband IPv4
• Broadband IPv4
• Parking IPv4
5.1 Configuring the IP address (narrowband and broadband)
PE Smart Gateway Neptune US is delivered with pre-configured addressing. Please refer to PE Smart Gateway Neptune
US Configuration Sheet to find out the IP addressing set on your device.
To change the configuration, connect a PC directly to PE Smart Gateway Neptune US and configure a static IP address
on the same product subnet.
Point your browser to PE Smart Gateway Neptune US Narrowband IPv4 address to reach the device management
interface.
After login (credentials are available on PE Smart Gateway Neptune US Configuration Sheet), click on “IP management”
and enter the desired network configuration, as provided by your network administrator. Click on “Save Item
Configuration”. If available, please enter your DNS server IP address(es).
PE Smart Gateway Neptune US will apply the new configuration and try to redirect your browser to the new web
interface address.
Connect PE Smart Gateway Neptune US to the customer’s local network, reconfigure the client PC to its usual IP address
and reload the page on your browser, or point the browser to PE Smart Gateway Neptune US assigned IP address.
5.2 Gateway to CMS
PE Smart Gateway Neptune US must be able to establish a TCP connection to the hosted instance of CMS Server on TCP
port 55555 (if not differently mentioned). Please DO NOT modify it, unless receiving specific instruction by Paradox
Engineering.