Installation Manual

PE Smart Gateway Neptune US
Installation manual
Document No. [DOC-INS-0059-02] Date of last revision [23.11.2018]
Page 12 / 30
4.3.3.1 Application of the voltage splicing tape
The application of the voltage splicing tape is highly recommended for final outdoor installations
The voltage splice tape shall be applied after that all antennas are mounted on PE Smart Gateway Neptune US.
Please follow these instructions to properly apply the tape.
After the application of the voltage splicing tape, please repeat the procedure with a further insulating tape to increase
the protection of the voltage splicing tape against outdoor conditions.
Close-up of a taped antenna
Ensure to tight the tape on each turn
Apply the tape to cover all the metallic bottom part of
all antenna connectors. Perform at least 5 turns on each
connector.
Cut the splicing tape at 20 cm and remove the protective film