Owner's Manual

10
OTHER CONNECTIONS AND CONTROLS:
ARC (USB-C) Input
This USB-C connection is used exclusively for connecting to a computer when running
the ARC Genesis calibration software. Further details on this feature can be found later
in this manual.
Power Mode
This switch is used to toggle the XR subwoofers power on method.
Auto
The subwoofer will automatically power on when an input signal is detected, and after
a period of inactivity, will automatically power down when no input signal is detected.
Please note the power on and power off sequences do not occur immediately, so some
delay is normal and to be expected.
Trigger
In this mode the XR subwoofer will power on and off accordingly, only when instructed
by a device connected to the 12V trigger input.
On
In this mode the XR subwoofer is always powered on and ready to play with no delay
caused by the power on or power off sequences. Please note that this mode does draw
more power when the subwoofer is not in use than the “Auto” mode as the subwoofers
electronics are always powered on in this mode.
Trigger In (12V)
Used to allow another device to control the XR subwoofers power on or power off state.
The XR must be in “Trigger” power mode to respond to these commands.
POWERED BY