Manual

DISASSEMBLY
STEP 1: Remove all ammunition
from the magazine. Firmly grasp
the metal magazine body in one
hand and with the other hand
grip the magazine’s base plate.
Use your thumb to slightly raise
the slotted tab at the rear of the
base plate.
CAUTION: Lift the slotted tab
only enough to clear the rear of
the magazine extension.
S
TEP 2: Slide the base plate toward
the front of the magazine to
remove it.
STEP 3: While holding the
magazine in one hand, use the
index finger of the other hand
to gently apply a small amount
of pressure to the release lever
at the bottom of the magazine
extension.
This will retract the two small tabs at the rear of the extension which keep it in place.
Gently increase the pressure on the release lever until some resistance is felt.
Figure 26
H
IGH-CAPACITY MAGAZINE (LEFT) IS FOR LAW ENFORCEMENT
ONLY. FOR RECREATIONAL USE, MAGAZINE CAPACITY IS
RESTRICTED TO 10 ROUNDS IN THE U.S.A. AND CANADA.
MAGAZINE
FOLLOWER
MAGAZINE
SPRING
MAGAZINE
EXTENSION
High-Capacity
Magazine Assembly
10-Round
Magazine Assembly
MAGAZINE
FLOOR
PLATE
MAGAZINE
BODY
MAGAZINE
RETAINING LIPS
floor plate out of the way, remove the spring and follower. Clean
all components, taking care to remove any powder deposits on
the magazine retaining lips and follower
(Figure 26).
NOTE: Place spring correctly oriented with closed loop
uppermost pointing forward.
36
DISASSEMBLY, CLEANING & REASSEMBLY
OF 10-ROUND PARA-ORDNANCE MAGAZINE
MAGAZINE
EXTENSION
(REAR)
RELEASE
LEVER
TWO SMALL
TABS (REAR)
SLOTTED
TAB ON
BASE PLATE
METAL
MAGAZINE
BODY
37
BEFORE PROCEEDING MAKE SURE YOU ARE
WEARING SAFETY GLASSES AND KEEP THE
MAGAZINE POINTED AWAY FROM YOUR FACE.