Manual

Clean all residue from the spring and from the

magazine follower.

CAUTION: Do not apply oil to any part or lubricate any

part of the magazine.

REASSEMBLY

STEP 5: Insert the spring and follower into the opening at

the bottom of the metal magazine body.

CAUTION: Make sure that the rounded top edge of the

follower is at the front of the magazine.

Position the bottom of the spring around the four posts on

the magazine extension. Then, gently compress the spring

with the magazine extension so that it is fully contained

inside the magazine body. Engage the round tab at the top

front of the magazine extension in the small hole at the

front of the magazine body.

While still holding the

spring compressed,

gently apply a tiny

amount of rearward

pressure to the lever at

the bottom of the

extension until

some resistance is felt.

Then, rotate the rear

of the extension

upwards so it engages the magazine body. Continue

rotating until the two small tabs are fully engaged.

Release the pressure from the lever at the bottom of the

extension. The magazine extension is now locked in place.