Manual

39
This will retract the two small tabs at the rear of the exten-
sion which keep it in place. Gently increase the pressure on
the release lever until some resistance is felt.
CAUTION: Do not apply excessive pressure to the release
lever or it may break off.
CAUTION: The spring and follower are compressed in the
magazine. Care should be taken during this step to prevent
them from flying out.
STEP4: While maintain-
ing the gentle pressure
on the release lever,
begin to rotate the
magazine extension
downward to release it
from the metal maga-
zine body. Release pres-
sure from the lever as
soon as the two small
tabs at the top rear
of the extension clear the magazine body. The extension
can now be removed by easing it slightly rearward to
release the round tab at the front. The spring and maga-
zine follower can now be removed through the opening at
the bottom of the metal magazine body. As you remove it,
note which end faces the front.
TWO
SMALL
TABS
(REAR)
ROUND TAB
(FRONT)
CLEANING
CAUTION: Do not attempt to remove the follower from the
spring.
Wipe the outside of the magazine with a rag. Insert a dry rag
through the opening
at the bottom of the metal magazine
body and remove all residue from the inside. Do the same
from the smaller opening at the top.