Manual

30
P14•45 Limited/P16•40 Limited/P13•45 Limited ONLY
SIGHT ADJUSTMENT
First, loosen the locking set screw (Figure 17) on the right
side of the rear sight with the 1.5mm hex wrench which has
been provided. To adjust your rear sight for elevation, use the
largest blade of the screwdriver which has been provided. To
raise the sight and thus raise the impact point of the bullet,
turn the screw counter-clockwise. When
adjustment is complete, retighten locking set screw. To adjust
for windage, turn the screw on the right side of the rear sight
clockwise to move the bullet’s impact to the right; counter-
clockwise to move impact to the left.
NOTE: There
is no locking
set screw for
the windage
adjustment
screw.
ELEVATION LOCKING
SET SCREW
WINDAGE
ADJUSTMENT
SCREW
ALWAYS WEAR SAFETY GLASSES AND KEEP
PISTOL POINTED AWAY FROM YOUR FACE, WHEN
PREPARING TO DISASSEMBLE YOUR PISTOL
TO AVOID INJURY TO THE EYES IN THE EVENT
THAT SOME COMPONENT MAY COME FLYING
LOOSE FROM YOUR GUN.
Figure 17