Manual

27
REASSEMBLY (continued)
STEP 1. Rotate barrel link forward and install the barrel
through the front of the slide.
STEP 2. To install the barrel bushing on the barrel, push
the barrel forward enough to allow you to slide the barrel
bushing onto it. Then push the bushing rearward until it
contacts the slide. Turn it clockwise to engage it in the slide.
STEP 3. Insert recoil guide by pushing it toward the front of
the slide (Figure 12).
Figure 12
SLIDE
RECOIL GUIDE
STEP 4. Slip recoil spring, closed end first, over the front of
the recoil spring guide, until the spring end makes contact
with the base of the guide.
STEP 5. Make sure the plunger lever is down (forward) at
the top of the receiver, and keep it down by tipping the
receiver forward. Wrap your fingers around the front of
the slide to hold the recoil spring assembly in position.
Now you can run the slide onto the receiver to the point
where you can see the barrel link through the slide stop
hole in the receiver. Insert the slide stop pin in and
through the receiver and barrel link.