Owner's Manual
Table Of Contents
n,
....
.
··o
Features
L494
Ill
15019
1 8
1. When connected to the battery it will continually supply power even after the c
ar
is turned off.
2. When connected to the c
ar
battery it will supply po
wer
to the device continually at all times unless the dev
ic
e is
manually powered o
ff
to provide 24 hours
of
monitoring and recording.
3. Low voltage protection function will detect when the battery voltage is getting too low and automatically switch
off
the device
to
guarantee that the vehicle will start normally.
4. Power input: DC 12-36V
5. Low voltage protection circuit design: when voltage
of
a 12V battery is lower than
11
.6
V,
23.
6V
for 24V battery and
35.2V for 36V battery, device will cut off device automatically to prevent draini
ng
the car battery and impede car
start-up.
Product parameters
Input voltage: DC 12V-36V, 1 A
Output voltage: DC 5V
Output current:
MAX
1.
8A
Low voltage protection parameter: 12V: lower than
11
.
6V
; 24 V: lower than23.6V; 36V: lower than 35.
2V
Installation instruction
The device can be connected to battery
or
other power supply within the range
of
12V-36V. There are BAT&ACC(+)
and GND(-) cables that can be connected with the following methods:( everything
was
fine here just add 'the' at end
of
sentence)
1. Connect device BAT&ACC(+) to power positive terminal
or
BAT yellow cable(+) of car device; connect device
GND(-) to power negative terminal
or
GND grounding wire(-) of car device allowing for 24 hours of monitoring and
recording.
2. Connect device BAT&ACC(+)
to
power positive terminal
or
ACC red cable(+)
of
car device; connect device
GND(-) to power negative terminal or GND grounding wire(-)
of
car device to allow control
of
the unit with start/stop
of engine.
•~muaJ
* Installation is not included with purchase. The buyer should install all devices purchased by Internet
or
vendor.
*
You
can install this product with a basic understanding
of
a car's electric circuit system.
If
the buyer is unsure
of
the circuit system we advise that you hire a professional to
do
it for you. All additional costs are the buyer's
responsibility.
* Do not modify/cut the cable during the warranty period. Returns are not accepted
if
the cable/device has been
altered in any
way
from its' original state.
* Rated current load
of
product is 2A (about
24W
for 12V power supply), Please make sure that the device
connected to this product has a current lower than the rated current load to prevent any hazardous/harmful incidents.
Installing the product
BAT
&ACC
(+)
GND
(-)
~-
-
-
---
-----------
-
-------------------------------------
Car Re
co
rder
1
DC
box BAT to car BAT
II
BAT (yellow wire+)
CD
BAT & ACC
r---
:
1 DC box GND to
car
GND
I
DC
box I
I GND
GND
~