User Manual

- 04 -

STEP A. Selection a dry wall to open a hole for fireplace box. Size of hole as below chat Figure (A)

STEP B. Fix the three wall anchors in each side of the fireplace box according to the dimensions Showed on

the drawing. Figure (B)

STEP C. Take off the two screws in both sides of fireplace. Figure (C)

STEP D. Have two person to take the glass panel out of the fireplace box. Place it to a soft and clean place.

Figure (D)

RECESSED TO WALL INSTALLATION

Framing Hole Size

Model Number

IF-1336

IF-1340

IF-1350

IF-1360

33.16”(84.3cm)

37.16”(94.4cm)

47.44”(120.5cm)

57.23”(145.4cm)

20.5”(52.1cm)

17”(43.2cm)

STEP E. Have two person to move the fireplace box to the wall hole.

If the appliance is fully recessed into the wall:

● Use the 4 screws(provided) to lock the appliance into wall with the existing two side flanges, see Figure(E)

● Install the media and re-install the glass front.

STEP F. Place the front panel lock the appliance. See Figure(F)

STEP G. Fireplace will be like this after installation Figure(G)

MINUMUM MANTEL CLEARANCES

WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE HEAT

RESISTANT TO PREVENT DISCOLOURATION.

WARNING