User Manual

PREPARATION
This product includes a GLASS panel! Always use extreme caution when handing glass. Failure
to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts and
assembly steps are grounded for wall-hanging or recessing use. Check the parts list to make sure nothing is
missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape measure; electric
drill; 1/4” wood drill bit, hammer.
- 02 -
The power cord supplied with the heater has
a plug with two flat blades (live and neutral)
and one round pin (ground). If a 3-slot
receptacle is not available, an adapter MUST
be used. The adapter MUST be properly
grounded to the outlet box (see figure at
right). (Note: Adapter NOT INCLUDED.)
SAVE THESE INSTRUCTIONS!
●
●
WARNING
PARTS & HARDWARE
A-Fireplace
E-Wall Bracket
Fixed on back of firebox
H-Log Set I - Plastic Tray
F-Decorative Crystals
B-Wood Screws
C-Drywall Anchors D-Metal Bracket
Remote control