User Manual
Buff using a soft cloth, slightly dampened with a citrus oil-based product.
DO NOT use brass polish or household cleaners as these products will damage the metal trim.
●
●
CARE AND MAINTENANCE
ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning,
performing maintenance, or moving this fireplace. Failure to do so could result in electric
shock, fire, or personal injury.
NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or
personal injury.
- 08 -
NOTICE
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an explosion.
Dispose of batteries at your local hazardous material processing center.
When the heater is first turned on, a slight odor may be odor may be present. This is normal
and should not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press
the buttons too quickly.Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe tempera-
ture, the heater will automatically turn OFF. To reset:
Remote Control Battery Information
Small remote control uses one CR2025 battery(included)
NOTE: Remote control battery used depends on the remote control type which selected above.
Unplug the power cord from the outlet.
Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a
vacuum to clean the vent areas.
With the POWER switch in the OFF position, plug the power cord back into the outlet.
If the problem continues, have your outlet and wiring inspected by a professional.
Cleaning
Metal:
Use a good quality glass cleaner and dry thoroughly with a paper towel or lint-free cloth.
NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.
●
●
Glass:
Use a vacuum or duster to remove dust and dirt from the heater and vent areas.
Clean the exterior of the fireplace with a slightly damp cloth or duster.
●
●
Vents:
1.
2.
3.
4.
5.