User's Manual

Chapter 7 Safety and Warranty 115
FCC COMPLIANCE INFORMATION
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference
received. Including interference that may cause
undesired operation.
INFORMATION TO THE USER
This equipment has been tested and found to comply
with the limits for a Class B digital device pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
Interference in a residential installation This
equipment generates, uses, and can radiate radio
frequency energy and, if Not installed and used in
accordance with the instructions, may cause harmful
Interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular Installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
y Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
y Connect the equipment into an outlet of a circuit different
from that to which the receiver is connected.
y Consult the dealer or an experienced radio/TV technician
for assistance.
CAUTION: Changes or modification not expressly
approved by the party responsible for Compliance could
void the user’s authority to operate the equipment.
Connecting of peripherals requires the use of grounded
shielded signal cables.