User's Manual

5
Important Safety Information
FCC Regulatory Compliance
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Your mobile device is a low power radio transmitter and receiver.
When it is ON, it receives and also sends out radio frequency (RF)
signals. In August 1996, the Federal Communications Commission
(FCC) adopted RF exposure guidelines with safety levels for mobile
devices. Those guidelines are consistent with safety standards
previously set by both U.S. and international standards bodies:
American National Standard Institute (ANSI), National Council of
Radiation Protection and Measurements (NCRP), and International
Commission on Non-Ionizing Radiation Protection (ICNRP). Those
standards were based on comprehensive and periodic evaluations of
the relevant scientific literature. The design of your phone complies
with the FCC guidelines and applicable.
Statement according to FCC part 15.105
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
x Reorient or relocate the receiving antenna.
x Increase the separation between the equipment and receiver.
x Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
x Consult the dealer or an experienced radio/TV technician for help.
Statement according to FCC part 15.21
Modifications not expressly approved by this company could void
the user’s authority to operate the equipment.
RF exposure FCC
For body worn operation, to maintain compliance with FCC RF
exposure guidelines, use only accessories that contain no metallic
components and provide a separation distance of 20 mm (0.6 inches)
to the body. Use of other accessories may violate FCC RF exposure
guidelines and should be avoided.
This device and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
Health and Safety Information FCC
This EUT has been shown to be capable of compliance for localized
specific absorption rate (SAR) for uncontrolled environment/general
population exposure limits specified in ANSI/IEEE Std. C95.1-1992 and
had been tested in accordance with the measurement procedures
specified in FCC/OET Bulletin 65 Supplement C (2001) and IEEE Std.
1528-2003 Ministry of Health (Canada), Safety Code 6. The standards
include a substantial safety margin designed to assure the safety of all
persons, regardless of age and health. The exposure standard for wireless
mobile phones employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.*