Operation Manual

01
02
03
05
06
07
04
68
69
Shortcut: From idle mode, press and hold the CLR Key to access the Voice
Commands menu and press the Right Soft Key
[Settings].
3. Select Automatic , Always Conrm or Never Conrm , then press the OK
Key [
SET ].
SENSITIVITY
The Sensitivity setting allows you to adjust the sensitivity monitoring of voice tones.
If you frequently experience the messages “
Please try again ” or “ Sorry Command
not recognized try again?
”, adjust the sensitivity toward Less Sensitive . If you
frequently experience false activations (when the phone recognizes a name you
didn’t say), adjust the sensitivity toward
More Sensitive .
1. Slide the phone up, press the [ MENU ], then press 9. Settings & Tools ,
3. Tools , 1. Voice Commands .
2. Press the Right Soft Key [ Settings ] and then press 2. Sensitivity .
3. Select More Sensitive , Automatic or Less Sensitive , then press the OK
Key [
SET ].
ADAPT VOICE
Voice Commands are speaker independent, which means that no training
or adaptation is required. Some users with heavy accents or unusual voice
characteristics may nd diculty in achieving high accuracy with speaker
independent Voice Commands, so the Adapt Voice feature allows users to
dramatically improve the recognition accuracy after adapting their voices. Users who
get acceptable recognition accuracy will nd no additional benet to performing the
Adapt Voice feature.
1. Slide the phone up, press the [ MENU ], then press 9. Settings & Tools ,
3. Tools , 1. Voice Commands .
2. Press the Right Soft Key [ Settings ] and then press 3. Adapt Voice .
3. Select
1. Train Voice or 2. Reset Voice , then press the OK Key.
• Train Voice: Requires that you make recordings of your voice to customize the voice
recognition system. It will take a few minutes.
•
Reset Voice: Once you nish the adaptation process, you can reset the adaptation to
the factory default. The Reset Voice option only appears after you nish
the Train Voice process.
4. “ Adaptation will take a couple of minutes to complete. Adapt in a
quiet room. Press OK to begin.
” will appear on the screen. Press the OK
Key. Wait for the beep, and then repeat the sentences using a normal tone
of voice.
5. When you are nished with a full session, you will reach a screen that reads
“
Adaptation Complete ”.
PROMPTS
Allows you to select voice command system characteristics.
1. Slide the phone up, press the [ MENU ], then press 9. Settings & Tools ,
3. Tools , 1. Voice Commands .
2. Press the Right Soft Key [ Settings ] and then press 4. Prompts .
3. Select
1. Mode , 2. Audio Playback or 3. Timeout , then press the OK Key.
• Mode: Select the voice command system mode from the following:
- Prompts: For handset to prompt for required information.
- Readout+Alerts: For handset to prompt for required information and readout the
contents of the screen and phone alerts.
- Readout: For handset to prompt for required information and readout the contents
of the screen.
- Tones Only: For handset to provide beeps only for audio guidance.
•
Audio Playback: Allows audio playback to play through the speakerphone or earpiece.
Select
Automatic , Speakerphone or Earpiece .
•
Timeout: Select a period of time either 5 seconds or 10 seconds which the system
listens for a command before timing out.
4. Select an option and press the OK Key [ SET ].
ABOUT
1. Slide the phone up, press the [ MENU ], then press 9. Settings & Tools ,
3. Tools , 1. Voice Commands .