Operation Manual

02
03
04
05
06
07
01
16
17
INSTALL BATTERY
1. Insert your nger tip into the slot (1), then push down on
top of the battery cover and slide it o to remove (2).
2. Slide the battery into the slot (3) by aligning the contacts
and press down (4) until you hear the “click”.
3. Align the cover tabs with the slots on the back of the
device and slide the battery cover onto the unit until it
snaps into place.
If the battery is not correctly placed in the compartment,
the handset will not turn on and/or the battery may detach
during use.
REMOVE BATTERY
1. To remove the battery cover, insert your nger tip into
the slot (1), then push down on top of the battery cover
and slide it o (2).
Caution:Do not expose to high temperature
(140/60). Do not disassemble .
Do not allow metal objects to contact or short
circuit the battery terminals. Do not incinerate
or expose to fire. To dispose of properly
(Ex:Recycling number 1-800-822-8837)
Attention: Ne pas exposer a des tempeatures
élevées (140/60). Ne pas démonter . Ne pas
laisser des objets métaliques venir en contact
avec les bornes de pile ni les court-circuiter.
Ne pas incinérer ni faire brûler.
Pour mettre au rebut adéquatement
(Ex:numéro de recyclage 1-800-822-8837)
Cuidado: No exponga a alta temperatura (140
/60). No desensamble. No permita que
objetos de metal entren en contacto o hagan
cortocircuito con los terminales de la batería.
No incinere ni exponga al fuego. Para eliminar
en forma adecuada (Por ejemplo:Número de
reciclaje 1-800-822-8837)
A
ttenti
Att
e
n
t
io
n:
Ne pa
s
e
x
p
oser
a
des tempeatu
res
14
0
/
60 ). Ne pas démonter. Ne pas
venir en conta
ct
Correct Incorrect
Correct Incorrect
2. Insert your ngernail into the slot (3) and lift the battery
from the compartment (4).
3. Align the cover tabs with the slots on the back of the
device and slide the battery cover onto the unit until it
snaps into place.
CHARGING YOUR BATTERY
1. Connect the USB data cable into the cableless wall
adapter.
2. Plug the USB data cable into the phone’s Charging/
Data Jack (making sure to align the connector as it
appears in the image to the right) and the wall
adapter end into an electrical outlet.
If the battery connector is not properly aligned, damage could occur to the charging
connector and the phone may not charge.
3. To remove the Wall Charger, pull the charger from the
device.
Correct Incorrect
Correct Incorrect