User's Manual

6. As shown in the figure below, connect the telephone (normal phone)
to the jack RJ-11. You may use any of the two RJ-11 jacks provided
by the terminal.
7. Connect the SMPS for FWT terminal to the DC-jack located on the left
side of the terminal. Insert the power jack properly until it does not move
f u r t h e r.
󱅊
N o t e : The terminal may be damaged if you attach the connector
opposite to the direction shown above. Please double-check
the direction and proceed to step 4
4. After connecting the battery connector to the circuit board, insert the
cover as shown in the figure below. Then, fix the cover with
the screws.
5. As shown in the figure below, insert the antenna along the arrow and
rotate it clock-wise.
HWT-2150
User Guide
Installation
1 0
1 1
hWT-2150(8-9) 2003.8.9 11:51 AM 페이지11