User's Manual

HWT-2150
User Guide
3 5
Supplement Service
3 4
Pick up the handset of the normal phone, press [####], and then
select a desired number from 04~08. ‘04’ indicates automatic call
send after 4 seconds and ‘08’ indicates automatic call send after
eight seconds.
#### 04~08
: Timed Hot Line Dial send time setting (Method 2)
Hook Flash Time (Click Time) Control
This function is used to set the time required to recognize click of the
hook switch for redial and speed dial. Default setting is 100-700ms.
- Hook Flash Time Control Method
Enter [##3233 5 Maintenance Code 8 1], enter two
digits (05~98) for the minimum time by the 10msec, and then
press the [] button to save.
##3233 5 Maintenance Code 8 1 05~98
: Hook Flash minimum time setting
Enter [##3233 5 Maintenance Code 8 2], enter two
digits (06~99) for the maximum time by the 10msec, and then
press the [] button to save.
##3233 5 Maintenance Code 8 2 06~99
: Hook Flash maximum time setting
R e f e r e n c e : If the minimum time is set to 50 ~ 90 msec, it is not available for dial pulse
type telephones.
Voice Priva c y Setting
The terminal supports voice privacy.
- Voice Privacy On
Enter [##3233 5 Maintenance Code 9 1] and press the
[] button to save.
- Voice Privacy Off
Enter [##3233 5 Maintenance Code 9 2] and press the
[] button to save.
##3233 5 Maintenance Code 9 1 or 2
: Voice Privacy on/off
Serial Interface Setting (None for HWP- 2 1 5 0 )
The terminal supports data serve when it is connected to the PC
through RS-232 serial interface. The HWT-2150 terminal provides
two data rates for PC interface. It provides 115200 bps for high-
speed packet data service and 19200 bps for modem, PC Fax and
low speed packet data service.
- Setting serial interface to 19200 bps
Enter [##3233 5 Maintenance Code 0, select “1”], and
then press the [] button to save.
##3233 5 Maintenance Code 0 1
: Setting the serial data baudrate to 19200 bps
hWT-2150(8-9) 2003.8.9 11:51 AM 페이지35