User's Manual

HWT-2150
User Guide
2 9
Supplement Service
2 8
Reset items and their status are listed below:
CLIP Setting
As the terminal type FWT has no display, the calling party’s number
can be indicated by connecting a specific module or a display type
telephone. This function is used to set communication method of the
m o d u l e .
- CLIP Setting Method
① Enter [##3233 → 5 → Maintenance Code → 1 → 1(DTMF
mode) or 2 (FSK mode)] and press the [✽] button to save.
##3233 → 5 → Maintenance Code → 1 → 1 or 2→ ✽
: CLIP setting
I t e m s S t a t u s
Speed dial
E m e r gency call hold
Hot line call
A l a r m
L o c k
E a r -piece volume
o f f
o f f
o f f
o f f
o f f
level 3
R e f e r e n c e : The Maintenance Code “2733” is used only for maintenance.
A n a l o g G3 Fax Standard Setting
The terminal can provide fax service using two types of Analog G3
Fax standards.
This function is used to set the standard.
- Analog G3 Fax Standard Setting
Analog G3 Fax service is provided using the IS-99/IS-707.4 based
PC Fax standard or the IS-707A.7 Analog G3 Fax standard. When
IS-99/IS-707.4 based PC Fax standard is used, you have to select
the default Fax receiving mode.
① IS-99/707.4 PC Fax setting
Enter [##3233 → 5 → Maintenance Code → 2 → 1], select “1”
(PC fax) or “2” (Analog G3 Fax), and then press the [✽] button to
s a v e .
##3233 → 5 → Maintenance Code → 2 → 1 → 1 or 2 →✽
: IS-99/707.4 PC Fax based mode setting
R e f e r e n c e : Default receiving mode is system-dependent (Unnecessary depending on
system configuration.). If the system is configured with single DN, the default receiving
mode is not applied as Fax receiving depends on user’s receive mode setting (Data
receiving through the analog G3 Fax in case of ****15* and through the PC in case of
****12*). Also, if the system is configured with two DNs (if fax calls are received
according to the service option determined by the system), the terminal receives calls
according to the default receiving mode setting.
hWT-2150(8-9) 2003.8.9 11:51 AM 페이지29