User's Manual

(Set to modem receive mode until power off ) .
⑥ Default setting is [✽✽✽✽1 0✽] .
• Setting with AT commands
This function is used to set the receiving mode according to data
service type,using the communication emulator program of PC
connected to the WLL terminal.
① Enter [AT +Q CVAD=0] in the communication emulator program
and press the Enter key.
·After the setting is completed, OK is indicated and the data service
receive mode is released.
② Enter [AT +Q CVAD=1] in the communication emulator program
and press the Enter key.
·After the setting is completed, OK is indicated and the fax receive
mode (one time) is set. The fax receive mode is released
automatically 10 minutes after setting.
③ Enter [AT +Q CVAD=2] in the communication emulator program
and press the Enter key.
·After the setting is completed, OK is indicated and the fax receive
mode is set (Set to fax receive mode until power off ) .
④ Enter [AT +Q CVAD=3] in the communication emulator program
and press the Enter key.
·After the setting is completed, OK is indicated and the modem
receive mode is set (one time). The modem receive mode is
released automatically 10 minutes after setting.
⑤ Enter [AT +Q CVAD=4] in the communication emulator program
and press the Enter key.
After the setting is completed, OK is indicated and the modem
receive mode is set (Set to modem receive mode until power off ) .
⑥ Default setting is [AT +Q CVA D = 0 ] .
HWT-2150
User Guide
2 1
Operation
2 0
Supplement Service
Speed dial
This function is used to save frequently used phone numbers in
advance and make a phone call quickly with the abbreviated code.
You can save up to 99 phone numbers. Default setting is off .
- Save phone number
Enter [##3233→1→1], enter a two-digit numbers(01~99) for the
address to save the phone number and press the [✽] button(save).
# # 3 2 3 3→1→1→address(2 digits)→phone numbers→✽
: save phone numbers
- Delete phone number
Enter [##3233→1→2], enter the address(01~99) to delete and press
[✽] button. To delete all phone numbers saved, enter [##3233→1→
3] and press the [✽] button.
##3233 → 1 → 2 → address(2 digits) → ✽ : delete one address
##3233 → 1 → 3 → ✽ : delete all address
- Speed dial on and off
Enter [##3233→1→4] and then press the [✽] button(on). The speed
dial mode is enabled only if the speed dial function is on although
phone numbers are saved in the memory.
To disable the function(off), enter [##3233→1→ 5] and then press
the [✽] button.
hWT-2150(8-9) 2003.8.9 11:51 AM 페이지21