User's Manual

Call Re c e i ve
- When the Normal Phone is On-hook State
① Pick up the handset when the normal phone rings.
② Speak to the called party when the line is connected.
③ Hang up the handset after conversation.
- When the Normal Phone is Off-hook State
① Click the hook switch(hook-flash) if the normal phone receives the
ring signal (Call receive in off-hook is allowed only if the dial tone
& warning tone are being sent and the bell rings through the
b u z z e r ) .
② Speak to the called party when the line is connected.
③ Hang up the handset after conversation
A n a l o g G3 Fax Serv i c e
To use the analog G3 fax service from the terminal equipped with the
analog G3 fax board, you have to send/receive documents
according to the following procedure:
- Sending Documents
Press [✽00] and then press the number of destination. The other
procedure is the same as that for general faxes.
- Receiving Documents
To receive documents from the analog G3 fax, set the terminal to the
Analog G3 fax receive mode first. Pick up the handset of the fax and
press [✽✽✽✽1 5 ✽]. The fax is set to the Analog G3 fax receive
mode(Set to Analog G3 fax receive mode until power off ) .
You can not receive voices unless you reset the Analog G3 fax
receive mode. To reset the Analog G3 fax receive mode, pick up the
HWT-2150
User Guide
1 9
Operation
1 8
handset of the fax and press [✽✽✽✽1 0 ✽]
D ata Serv i c e
When a PC is connected to the WLL terminal, the data service can
provide Internet and PC communication and fax send/receive. As
wireless data communication service may not be provided
depending on service providers, please check if the service provider
provides this service. This service is available after purchasing data
communication cable from the service provider.
For computer environment setup and other details, refer to the User
Manual provided when you purchase the data communication cable.
- Data Service Receive Mode Setting
• Setting with a normal phone
This function is used to set the receive mode according to data
service type, using the normal phone connected to the W L L
t e r m i n a l
① Pick up the handset of the normal phone and press
[✽✽✽✽1 0 ✽] to reset the data service receive mode.
② Pick up the handset of the normal phone and press
[✽✽✽✽11✽] to set fax receive mode(one time).
The fax receive mode is released automatically 10 minutes after
s e t t i n g .
③ Pick up the handset of the normal phone and press
[✽✽✽✽1 2 ✽] to set fax receive mode
(Set to fax receive mode until power off ) .
④ Pick up the handset of the normal phone and press
[✽✽✽✽1 3 ✽] to set modem receive mode(one time).
The modem receive mode is released automatically 10 minutes
after setting.
⑤ Pick up the handset of the normal phone and press
[✽✽✽✽1 4 ✽] to set modem receive mode
hWT-2150(8-9) 2003.8.9 11:51 AM 페이지19