User's Manual

W a l l b r a c k e t I n s t a l l a t i o n
1. In case of concrete wall, attach the Installation Sheet to the place
that you want and make holes with a drill.
2. As shown in the figure below, fix the screws into the holes.
※ In case of wooden wall, skip drilling and directly fix the screws to the
Installation Sheet. The distance from the wall to the head of the
screw is the same as the figure in step 2.
Installation Sheet
Wall
Wall
25.0mm
3.5mm
Screw
8. Connect the power plug of the SMPS to the power receptacle.
9. Set the power switch located at the back of the terminal to ON.
The following actions occur :
• All of the four LEDs are lighted, and then the LED corresponding
to the power currently applied is lighted.
• If the service available, the SERVICE LED is lighted.
AC plug
(110V or 220V )
HWT-2150
User Guide
1 3
Installation
1 2
hWT-2150(8-9) 2003.8.9 11:51 AM 페이지13