User's Manual

HWT-2150
User Guide
3 7
Supplement Service
3 6
- Setting Serial Interface to 115200 bps
Enter [##3233 → 5 → Maintenance Code → 0, select “2”], and then
press the [✽] button to save.
##3233 → 5 → Maintenance Code → 0 → 2 →✽
: Setting the serial data baudrate to 115200 bps
A Key Value Input
The terminal supports OTASP service that requires authentication.
This function is used to enter A key value required for the
authentication procedure.
- A Key Input
Enter [##3233 → 6 → Maintenance Code → 1], enter a number
corresponding to the A Key value up to 26 digits, and then press the
[✽]button to save.
##3233 → 6 → Maintenance Code → 1 →
A Key No.(26 digits) → ✽
: A Key input
N e t wo rk Dial Tone Setting
The terminal provides the network dial tone depending on
configuration of the system (system dependent). The terminal
connected to a system that provides the network dial tone provides
“LE-Generated dial tone”. Other systems provide “NIU-generated
dial tone”.
- Network Dial Tone Off
Enter [##3233 → 6 → Maintenance Code → 2, select “1”], and then
press the [✽] button to save.
##3233 → 6 → Maintenance Code → 2 → 1 → ✽
: NIU-generated dial tone setting
- Network Dial Tone On
Enter [##3233 → 6 → Maintenance Code → 2, select “2”], and then
press the [✽] button to save.
##3233 → 6 → Maintenance Code → 2 → 2 → ✽
: LE-Generated dial tone setting
System Pa rameter Input
You can enter/change channel number and MIN number of the
system parameters with the handset.
- Channel Number Input
Enter ##3233 → 9 → Maintenance Code → 1~4, enter three digits
of the channel number, and then press the [✽] button to save.
1 : Primary System A channel
2 : Secondary System A channel
3 : Primary System B channel
4 : Secondary System B channel
##3233 → 9 → Maintenance Code → 1~4 → Channel No. → ✽
: Channel number input
hWT-2150(8-9) 2003.8.9 11:51 AM 페이지37