*HYUNDAI 1. Introduction The WLL {Wireless Local Loop) terminal is designed to provide users with ful range of communication services in COMA (Code Division Multiple Access) networks. Before using the product, please read carefully this chapter. HWP 130/230 Main Features 13-058 support Data rate: 64kbps (max) Backward compatibility New Soft Han doff Algorithm i Enhanced Hard Han doff “True IMS! (International Mobile Subscriber Identification) -.
*HYUNDAI HYUNDAI] 1.1 Notices for Using Do rot disassemble or alter the WELL terminal on your own, * Accessories Do not ouch antenna during the call. Do not hold the WLL terminal in hot or moist places. Be careful not to moisten the terminal root spill any liquid on it. This may cause irrevocable damage. | + Avoid terminal shocks and vibrations, Store the terminal in a safe place. Do not use the terminal near to explosives or in places where combustible quids are used.
HYUNDAI SILENCED RSI LED goes “ON, wassailing is GOOD”. R91 LED gods “ON and OFF at the interval of 1 second, she the state of reins-seiving is whee the state of “NOT GOOEY, RSFSR LED goes "ON and OFF" at the interval of 15 seconds, when the sta of trans-ceiving is “NO SERVICE” POWER LED Indicates whether the power is supplied by xterm] AMPS or by internal battery. The LED 200d ON" when textual power is supplied. When the terminal] apostasies on infernal backup tater, the LED hoed OFF".
*HYUNDAI ) Tum on the power switch as shown on the picture. The WLL terminal turns on and a beep sound is heard. HYUNDAI Wall Bracket Mounting (I} For the concrete wall, place the mounting plate whets the WLL terminal should be installed, and drill two according 16 +1 marks. Mounting Plate Screw up as shown in the figure below.
*HYUNDAI HYUNDAI The distance between the screw head and the wall is to be 2.0mm as shown on the figure above. 2) Insert the parts A1, A2 of the wall bracket into the WLL terminal body, and gently push in the. parts B1, B2. i External Antenna Bottom of phone | {i} Disconnect antenna from the phone @ Insert screws info the C1, C2 notches, and pull the body downward. As this takes place, make sure about the distance between the screw head and the wall, lest the body hangs askew.
*HYUNDAI *HYUNDAI 2. Using Basic Functions 2.2 To Receiving an Incoming Call 221 Chinook state 2.1 Call Process & Calf Process by Special Function [the telephone starts ringing, Pick up the handset. 2.1.1 Call press + Speak on the telephone. | + Place the handset an-hook to terminate the call, { + Pick up the handset. You wilt hear the dial tone. (In the’ No Service” state however, the i warning tone is heard at the interval of 8.5 second.) 2.2.
