Panowin F1 Heated Bed Platform (HBP) Instruction
磐纹科技 上海 有限公司 Package list 3M sticker HBP Cable Spacer Zip tie Steps: 1.
2. Put the spacer on the sliding module of Y axis； 3. Connect the short end of the cable with the HBP as picture shows.
4. Use the zip tie to lock the cable with the HBP； 5. Remove the rest of the zip tie and make sure the cable is fixed； 6.
7. Lock the HBP with flat screws； 8.
9. Connect the longer side of the cable with the 4 pin port on the PCB controller； 10.
11. Stick the sticker on the HBP and make sure the surface is flat； 12. The LED light on the bottom shows the working condition of the HBP. Power 13. Temperature There maybe a little offset between the nozzle and the platform after the installation. Please adjust the nozzle height before print.
